Aircraft Hardware

106-71098 is a North American Aviation support bracket for the SCR-522 VHF radio antenna mast on the P-51D Mustang. The SCR-522 was the standard VHF transceiver fitted to the P-51D.Constructed from...

511814 is a gasket for the adjusting screw packing in a fluid system valve or control assembly. This type of gasket seals the packing area around an adjusting screw to prevent fluid leakage. Contact...

65135 is a lock nut for aircraft use. Lock nuts incorporate a friction-locking feature to resist loosening under vibration. Part Number: 65135 Type: Nut, Lock Application: Aircraft structural and...

54254 is a Bendix center bushing used in brake or landing gear assemblies. Center bushings provide a bearing surface at the center bore of a hub, wheel, or actuator component. Part Number: 54254...

53876 is a Bendix bushing for the link-to-strut connection in a landing gear or brake system assembly. Bendix bushings of this type are used to provide a wear surface at the pivot or attachment point...

404307 is a rubber boot manufactured by Bendix Pacific Division, used as a protective cover for hydraulic sequence valves in the 403196 Series, 402004 Series, and 401275-4 Series. The boot shields...

434126 is an exhaust pipe clamp assembly for the Wright R-1820 Cyclone radial engine, used to secure and retain exhaust pipe joints within the engine exhaust system. Maintains exhaust pipe alignment...

471-2D is an Aeroquip reusable hose end fitting for Aeroquip 306 low-pressure rubber hose, used in aircraft hydraulic, fuel, oil, pneumatic, and coolant systems. The fitting consists of three...

471-3D is an Aeroquip reusable hose end fitting for Aeroquip 306 low-pressure rubber hose, used in aircraft hydraulic, fuel, oil, pneumatic, and coolant systems. The fitting consists of three...

471-4D is an Aeroquip reusable hose end fitting for Aeroquip 306 low-pressure rubber hose, used in aircraft hydraulic, fuel, oil, pneumatic, and coolant systems. The fitting consists of three...

471-6D is an Aeroquip reusable hose end fitting for Aeroquip 306 low-pressure rubber hose, used in aircraft hydraulic, fuel, oil, pneumatic, and coolant systems. The fitting consists of three...

471-8D is an Aeroquip reusable hose end fitting for Aeroquip 306 low-pressure rubber hose, used in aircraft hydraulic, fuel, oil, pneumatic, and coolant systems. The fitting consists of three...

471-10D is an Aeroquip reusable hose end fitting for Aeroquip 306 low-pressure rubber hose, used in aircraft hydraulic, fuel, oil, pneumatic, and coolant systems. The fitting consists of three...

FC-5921 is a Wagner Mfg. rubber boot - master cylinder for the Bendix / Gidair brake master cylinder used in Boeing Stearman aircraft. Protects the push rod and piston rod end from contamination,...

GA52152-D is a Gidair piston - master cylinder (3/4" bore) for the Bendix / Gidair brake master cylinder used in Boeing Stearman aircraft. The primary pressure-generating piston for the 3/4" bore...